Fail to move a card between printer and other module(flipper/laminator) -. Check the rollers and cards, and clean them if they are dirty -. Check the operating state of the card feeding rollers and sensors
The printer can’t wind the ribbon in printing or booting up. -. Check the operating state of the Ribbon Motor -. Check the operating state of the ribbon encoder sensor and gears
1. Please open the Input Hopper Cover and load a card or cards on the Input Hopper as shown below. When you load a card on the Input Hopper, do not push the card into the SMART Printer or it may cause the card feeder to become obstructed, ...
1. Check the card thickness control lever and adjust it to the current card's thickness. 2. Check the contaminated state of the Hopper Roller and clean it. When the Hopper Roller is contaminated, the SMART Printer may be unable to move ...
1. Check the ribbon balance using the left LED button on the front panel of the SMART Printer. ※ We supply extra panels on our ribbon to prepare for snapping or skipping. Even if unused panels remain on the ribbon core, when the ribbon balance ...